[Nov 30, 2025] Latest CCSE 156-315.81.20 Actual Free Exam Questions
CCSE 156-315.81.20 Dumps Updated Practice Test and 615 unique questions
NEW QUESTION # 325
There are two R77.30 Security Gateways in the Firewall Cluster. They are named FW_A and FW_B.
The cluster is configured to work as HA (High availability) with default cluster configuration. FW_A is configured to have higher priority than FW_B. FW_A was active and processing the traffic in the morning. FW_B was standby. Around 1100 am, its interfaces went down and this caused a failover. FW_B became active. After an hour, FW_A's interface issues were resolved and it became operational.
When it re-joins the cluster, will it become active automatically?
- A. No, since 'maintain' current active cluster member' option is enabled by default on the Global Properties.
- B. Yes, since 'Switch to higher priority cluster member' option on the cluster object properties is enabled by default.
- C. Yes, since 'Switch to higher priority cluster member' option is enabled by default on the Global Properties.
- D. No, since 'maintain' current active cluster member' option on the cluster object properties is enabled by default.
Answer: D
NEW QUESTION # 326
What traffic does the Anti-bot feature block?
- A. Command and Control traffic to servers with reputation for hosting malware
- B. Command and Control traffic from hosts that have been identified as infected
- C. Network traffic that is directed to unknown or malicious servers
- D. Network traffic to hosts that have been identified as infected
Answer: B
NEW QUESTION # 327
The Check Point installation history feature in provides the following:
- A. Policy Installation Date, view install changes and install specific version
- B. View install changes
- C. Policy Installation Date only
- D. View install changes and install specific version
Answer: A
NEW QUESTION # 328
When simulating a problem on ClusterXL cluster with cphaprob -d STOP -s problem -t 0 register, to initiate a failover on an active cluster member, what command allows you remove the problematic state?
- A. cphaprob -d STOP unregister
- B. cphaprob -d unregister STOP
- C. cphaprob unregister STOP
- D. cphaprob STOP unregister
Answer: A
NEW QUESTION # 329
What is Dynamic Balancing?
- A. It is a ClusterXL feature that switches an HA cluster into an LS cluster if required to maximize throughput
- B. It is a CoreXL feature that assigns the SND to network interfaces to balance the RX Cache of the interfaces
- C. It is a new feature that is capable of dynamically reserve the amount of Hash kernel memory to reflect the resource usage necessary for maximizing the session rate.
- D. It is a feature that uses a daemon to balance the required number of firewall instances and SNDs based on the current load
Answer: D
NEW QUESTION # 330
Which Check Point daemon monitors the other daemons?
- A. cpd
- B. fwm
- C. cpwd
- D. fwssd
Answer: C
NEW QUESTION # 331
Which file contains the host address to be published, the MAC address that needs to be associated with the IP Address, and the unique IP of the interface that responds to ARP request?
- A. /var/opt/CPshrd-R81/conf/local.arp
- B. $FWDIR/conf/local.arp
- C. /opt/CPshrd-R81/conf/local.arp
- D. $CPDIR/conf/local.arp
Answer: B
NEW QUESTION # 332
The Security Gateway is installed on GAIA R81. The default port for the Web User Interface is ______.
- A. TCP 4433
- B. TCP 18211
- C. TCP 257
- D. TCP 443
Answer: D
NEW QUESTION # 333
What is not a purpose of the deployment of Check Point API?
- A. Integrate Check Point products with 3rd party solution
- B. Create products that use and enhance the Check Point solution
- C. Create a customized GUI Client for manipulating the objects database
- D. Execute an automated script to perform common tasks
Answer: C
NEW QUESTION # 334
How can SmartView application accessed?
- A. https://<Security Management host name>:4434/smartview/
- B. http://<Security Management IP Address>/smartview
- C. https://<Security Management IP Address>/smartview/
- D. http://<Security Management IP Address>:4434/smartview/
Answer: C
NEW QUESTION # 335
When SecureXL is enabled, all packets should be accelerated, except packets that match the following conditions:
- A. CIFS packets
- B. All IPv6 Traffic
- C. All UDP packets
- D. All packets that match a rule whose source or destination is the Outside Corporate Network
Answer: A
NEW QUESTION # 336
Pamela is Cyber Security Engineer working for Global Instance Firm with large scale deployment of Check Point Enterprise Appliances using GAiA/R81.20. Company's Developer Team is having random access issue to newly deployed Application Server in DMZ's Application Server Farm Tier and blames DMZ Security Gateway as root cause. The ticket has been created and issue is at Pamela's desk for an investigation. Pamela decides to use Check Point's Packet Analyzer Tool-fw monitor to iron out the issue during approved Maintenance window.
What do you recommend as the best suggestion for Pamela to make sure she successfully captures entire traffic in context of Firewall and problematic traffic?
- A. Pamela should use tcpdump over fw monitor tool as tcpdump works at OS-level and captures entire traffic.
- B. Pamela should check SecureXL status on DMZ Security gateway and if it's turned ON. She should turn OFF SecureXL before using fw monitor to avoid misleading traffic captures.
- C. Pamela should use snoop over fw monitor tool as snoop works at NIC driver level and captures entire traffic.
- D. Pamela should check SecureXL status on DMZ Security Gateway and if it's turned OFF. She should turn ON SecureXL before using fw monitor to avoid misleading traffic captures.
Answer: B
NEW QUESTION # 337
Which two Cluster Solutions are available under R81.20?
- A. ClusterXL and NSRP
- B. VRRPandHSRP
- C. VRRP and IP Clustering
- D. ClusterXL and VRitP
Answer: D
NEW QUESTION # 338
How many users can have read/write access in Gaia at one time?
- A. Two
- B. Infinite
- C. One
- D. Three
Answer: C
NEW QUESTION # 339
How does the Anti-Virus feature of the Threat Prevention policy block traffic from infected websites?
- A. By dropping traffic from websites identified through ThreatCloud Verification and URL Caching
- B. By allowing traffic from websites that are known to run Antivirus Software on servers regularly
- C. By dropping traffic that is not proven to be from clean websites in the URL Filtering blade
- D. By matching logs against ThreatCloud information about the reputation of the website
Answer: D
NEW QUESTION # 340
What is the correct order of the default "fw monitor" inspection points?
- A. l, i, O, o
- B. i, l, o, O
- C. 1,2,3,4
- D. i, o, l, O
Answer: B
NEW QUESTION # 341
Vanessa is firewall administrator in her company. Her company is using Check Point firewall on a central and several remote locations which are managed centrally by R77.30 Security Management Server. On central location is installed R77.30 Gateway on Open server. Remote locations are using Check Point UTM-1570 series appliances with R75.30 and some of them are using a UTM-1-Edge-X or Edge-W with latest available firmware. She is in process of migrating to R81.
What can cause Vanessa unnecessary problems, if she didn't check all requirements for migration to R81?
- A. Unsupported version on UTM-1 570 series appliance
- B. Unsupported appliances on remote locations
- C. Missing an installed R77.20 Add-on on Security Management Server
- D. Unsupported firmware on UTM-1 Edge-W appliance
Answer: C
NEW QUESTION # 342
Which statement is WRONG regarding the usage of the Central Deployment in SmartConsole?
- A. You can install Jumbo Hotfix accumulators with the Central Deployment in SmartConsole.
- B. You can install Hotfixes with the Central Deployment in SmartConsole
- C. You can upgrade your cluster without user intervention with the Central Deployment in SmartConsole from R80.40 to R81.20.
- D. Only be installed Hotfixes can with the Central Deployment in SmartConsole
Answer: D
NEW QUESTION # 343
Which command can you use to verify the number of active concurrent connections?
- A. fw conn all
- B. fw ctl pstat
- C. show all connections
- D. show connections
Answer: B
NEW QUESTION # 344
On what port does the CPM process run?
- A. TCP 857
- B. TCP 900
- C. TCP 18192
- D. TCP 19009
Answer: D
NEW QUESTION # 345
You are working with multiple Security Gateways enforcing an extensive number of rules.
To simplify security administration, which action would you choose?
- A. Run separate SmartConsole instances to login and configure each Security Gateway directly.
- B. Eliminate all possible contradictory rules such as the Stealth or Cleanup rules.
- C. Create a separate Security Policy package for each remote Security Gateway.
- D. Create network objects that restricts all applicable rules to only certain networks.
Answer: C
NEW QUESTION # 346
What is the command to see cluster status in cli expert mode?
- A. fw ctl stat
- B. clusterXL stat
- C. cphaprob stat
- D. clusterXL status
Answer: C
NEW QUESTION # 347
An established connection is going to www.google.com. The Application Control Blade Is inspecting the traffic.
If SecureXL and CoreXL are both enabled, which path is handling the traffic?
- A. Accelerated Path
- B. Fast Path
- C. Slow Path
- D. Medium Path
Answer: A
NEW QUESTION # 348
......
Verified 156-315.81.20 dumps Q&As - 100% Pass from Dumpexams: https://www.dumpexams.com/156-315.81.20-real-answers.html
Latest 100% Exam Passing Ratio - 156-315.81.20 Dumps PDF: https://drive.google.com/open?id=16m_Qb6r1C2yHgy9TosxmRHEAv9TIyQ4U