Get Latest [Oct-2021] Conduct effective penetration tests using Dumpexams H12-211-ENU
Penetration testers simulate H12-211-ENU exam PDF
NEW QUESTION 425
In the VRP system, what are the functions of Ctrl+Z? (Multiple Choice)
- A. Exit from the current view.
- B. Exit from the interface view.
- C. Return from the system view to the user view.
- D. Exit from the console interface view.
- E. Return to the user view.
Answer: C,E
NEW QUESTION 426
Refer to the graphic.
The administrator has configured an IP address for Host A and Host B, but had forgotten to configure a default gateway.
What effect will this have on the hosts?
- A. Hose will be unable to communicate unless arp-proxy is enabled on the router.
- B. Host A will be unable to connect to the router interface G0/0/0.
- C. The host will be unable to reach neither the local nor remote network destinations.
- D. Neither host will be affected, and therefore will be able to communicate with the peer.
Answer: A
NEW QUESTION 427
Which of the following are routing protocols? (Multiple Choice)
- A. IPX.
- B. BGP.
- C. IP.
- D. OSPF.
Answer: B,D
NEW QUESTION 428
The following figure shows the encapsulation format of the data packet in IPsec VPN. Which format is the type of data packet used toencapsulate in IPsec VPN?
- A. Transmission mode
- B. Universal mode
- C. This encapsulation is error
- D. Tunnel mode
Answer: D
NEW QUESTION 429
As shown in the following figure, which of the following configurations can be used to make Host A and Host B unable to communicate with each other? (Multiple Choice)
- A. acl number 2000 rule 5 deny source 100.0.12.0 0.0.0.255 # interface GigabitEthernet0/0/1 traffic-filter outbound acl 2000 #
- B. lacl number 2000 rule 5 deny source 100.0.12.0 0.0.0.255 # interface GigabitEthernet0/0/3 traffic-filter inbound acl 2000 #
- C. acl number 2000 rule 5 deny source 100.0.12.0 0.0.0.255 # interface GigabitEthernet 0/0/2 traffic-filter inbound acl 2000 #
- D. acl number 2000 rule 5 deny source 100.0.12.0 0.0.0.255 # interface GigabitEthernet0/0/1 traffic-filter inbound acl 2000 #
Answer: A,C
NEW QUESTION 430
As shown in the figure, the network administrator creates VLAN 2 on the SWA and SWB, and configures the ports connected to the host on the two switches as access ports and assigns them to VLAN 2. Configure G0/0/1 of the SA and G0/0/2 of the SWB as trunk ports to allow all VLANs to pass. To achieve normal communication between the two hosts, he also needs ().
- A. Configure G0/0/1 on the SWC as the trunk port and allow VLAN 2 to pass.
- B. Create VLAN 2 on the SWC.
- C. Create VLAN 2 on the SWC, configure G0/0/1 and G0/0/2 as trunk ports and allow VLAN 2 to pass.
- D. Configure G0/0/1 and G0/0/2 on the SWC as trunk ports and allow VLAN 2 to pass.
Answer: C
NEW QUESTION 431
On Huawei devices, which of the following methods can be used in OSPF router ID selection? (Multiple Choice)
- A. A valid router ID can be configured manually.
- B. A Huawei switch may use the largest IP address of VLANIF interfaces as the router ID.
- C. The default ID 127.0.0.1 is selected as the router ID.
- D. If loopback interfaces are not configured, the largest IP address of an interface is selected as the router ID.
- E. If a loopback interface is configured, the largest IP address of the loopback interface is selected as the router ID.
Answer: A,B,D,E
NEW QUESTION 432
Which of the following parts does the global unicast address consist of? (Multiple Choice)
- A. Global Routing Prefix
- B. Subnet ID
- C. Protocol ID
- D. Interface ID
Answer: A,B,D
NEW QUESTION 433
Refer to the graphic. IPsec VPN uses ESP to encrypt which fields?
- A. ESP, TCP and Data.
- B. ESP, TCP, Data, ESP Trailer and ESP Auth.
- C. TCP, Data and ESP Trailer.
- D. ESP, TCP, Data and ESP Trailer.
Answer: C
NEW QUESTION 434
In order to check if the interface serial 1/0/0 of the router is working in either DCE or DTE mode, command () is used.
- A. display mode serial 1/0/0.
- B. display interface serial 1/0/0.
- C. display current-configuration.
- D. display controller,
Answer: B
NEW QUESTION 435
Refer to the display output.
What can be determined based on the output of the display command?
- A. Interface GigabitEthernet 0/0/0 is not associated with a dynamically defined route.
- B. Interface GigabitEthernet 0/0/0 is connected to a wrong cable
- C. Interface GigabitEthernet 0/0/0 is not associated with an IP address
- D. Interface GigabitEthernet 0/0/0 has been manually shut down by an administrator.
Answer: D
NEW QUESTION 436
If AH and ESP are both required to protect data streams between IPsec peers, how many Security Associations (SA) are required ?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 437
Which of the following functions are supported by the LCP protocol in the PPP protocol? (Multiple choice)
- A. Detect link loops
- B. Negotiate the maximum receiving unit MRU
- C. Negotiate the network layer address
- D. Negotiate the authentication protocol
Answer: A,B,D
NEW QUESTION 438
In an RIP process on a Huawei device, you can use the preference command to configure the RIP route preference. After executing the command, you can specify routing policies to configure preferences for the routes meeting requirements.
- A. TRUE
- B. FALSE
Answer: A
NEW QUESTION 439
HhaweiGigabitEthernet0/0/1] port link-type access
[Huawei-GigabitEthernet0/0/1] port default vlan 10
[Huawei-GigabitEthernet0/0/2] port link-type trunk
[Huawei-GigabitEthernet0/0/2] port trunk allow-pass vlan 10
According to the command shown above, which of the following descriptions is correct? (Multiple choice)
- A. The PVID of GigabitEthernet0/0/1 port is 1.
- B. The PVID of GigabitEthernet0/0/1 port is 10.
- C. The PVID of GigabitEthernet0/0/2 port is 1.
- D. The PVID of GigabitEthernet0/0/2 port is 10
Answer: B,C
NEW QUESTION 440
......
Tested Material Used To H12-211-ENU Test Engine: https://www.dumpexams.com/H12-211-ENU-real-answers.html