Pass HPE2-W09 Exam in First Attempt Guaranteed 2021 Dumps!
HPE2-W09 Dumps Full Questions - Exam Study Guide
NEW QUESTION 23
Is this a requirement for implementing Priority Flow Control (PFC) on an ArubaOS-CX switch interface?
Solution: configuring trust of Cos on the interface
- A. No
- B. Yes
Answer: B
NEW QUESTION 24
You enter this command on an ArubaOS-CX switch:
Switch# show erps status ring 1
Is this what the specified status means?
Solution: The status is Idle, which means that the ring is up and fully connected with the RPL port blocked.
- A. No
- B. Yes
Answer: A
NEW QUESTION 25
Does this correctly describe how Network Analytics Engine (NAE) agents work?
Solution: Agents write data to the switch's current state database.
- A. No
- B. Yes
Answer: B
NEW QUESTION 26
Is this correct positioning of AtubaOS-CX switches in the data center?
Solution: Aruba CX 8325 switches are an appropriate choice for leaf switches in a leaf-spine topology that uses Virtual Extensible LAN (VXLAN) with Ethernet VPN (EVPN).
- A. No
- B. Yes
Answer: A
NEW QUESTION 27
Is this part of the process for using NetEdit to update firmware on ArubaOS-CX switches?
Solution: Use a firmware update plan to manage both updating the Image on selected devices and reboot.
- A. No
- B. Yes
Answer: A
NEW QUESTION 28
Refer to the exhibit.
You want to enable devices in VRF B and VRF C to reach shared resources in VRFA.
is this a valid strategy for meeting this goal?
Solution: Create a separate OSPF process for each VRF on Switch-1. Then redistribute each process into the other VRFs' processes.
- A. No
- B. Yes
Answer: A
NEW QUESTION 29
You plan to use multi-protocol BGP to implement dynamic VRF route leaking on an ArubaOS-CX switch.
Is this a rule for the setup?
Solution: You cannot leak multicast routes.
- A. No
- B. Yes
Answer: A
NEW QUESTION 30
Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring?
Solution: Implement Virtual Switching Extension (VSX) on pairs of ERPS switches at the same site. Then combine multiple links between two data centers into VSX LAGs (M-LAGs).
- A. No
- B. Yes
Answer: B
NEW QUESTION 31
Refer to the exhibits.
Is this how the switch handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.2. but not 192.168.1.3.
- A. No
- B. Yes
Answer: B
NEW QUESTION 32
Switch-1 and Switch-2 are AruDaOS-CX switches, which ate part of a Virtual Switching Extension (VSX) fabric. Switch-2 is the primary member. Switch-2 experiences a power failure while Switch-l remains up. Switch-2's power recovers, and Switch-2 reboots.
Solution: Switch-2 wails a period called the link-up delay before it enables Switched Virtual Interfaces (SVls) on its VSX LAGs.
- A. No
- B. Yes
Answer: B
NEW QUESTION 33
Refer to the exhibits.
Is this how the switch handles the traffic?
Solution: A frame with destination MAC address, 00:50:56:15:16:28, arrives with a VLAN 10 tag on 1/1/1 on Switch-1. Switch-1 encapsulates the frame with VXLAN and an IP header destined to 192.168.1.2.
- A. No
- B. Yes
Answer: A
NEW QUESTION 34
Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring?
Solution: Combine multiple links between two data centers into link aggregations (but not multi-chassis ones).
- A. No
- B. Yes
Answer: A
NEW QUESTION 35
Does this correctly describe Network Analytics Engine (NAE) limitations on ArubaOS-CX switches?
Solution: Different switches have different limitations for the number of NAE scripts, monitors, and agents supported.
- A. No
- B. Yes
Answer: A
NEW QUESTION 36
Is this a rule for configuring schedule profiles on an ArubaOS-CX switch?
Solution: With the exception of a single strict priority queue, all queues must use the same scheduling algorithm.
- A. No
- B. Yes
Answer: B
NEW QUESTION 37
Can you attach this type of ArubaOS-CX interface to a VRF?
Solution: A loopback interface
- A. No
- B. Yes
Answer: B
NEW QUESTION 38
Refer to the exhibit.
Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?
Solution: To reduce the amount of traffic sent over the ISI between Switch-1 and Swltch-2. enable active forwarding on LAG 100 on both Switch-1 and Switch-2.
- A. No
- B. Yes
Answer: B
NEW QUESTION 39
Does this correctly describe how the Virtual Switching Extension (VSX) fabric reacts to various component failure scenarios?
Solution: The keepalive goes down, ISL link remains up. Switch-1 and Switch-2 remains up. The Split-recovery mode is disabled. In this case the secondary switch shutdowns Svls.
- A. No
- B. Yes
Answer: A
NEW QUESTION 40
You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?
Solution: The wait to restore timer (WTR) Is set in units of minutes; you can set it to prevent frequent topology changes due to a link going up and down.
- A. No
- B. Yes
Answer: A
NEW QUESTION 41
Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?
Solution: Different virtual MAC must be used for IPv4 and IPv6 Active Gateway.
- A. No
- B. Yes
Answer: A
NEW QUESTION 42
Can you attach this type of ArubaOS-CX interface to a VRF?
Solution: A physical interface using Layer 2 mode
- A. No
- B. Yes
Answer: A
NEW QUESTION 43
......
HPE Product Certified Free Certification Exam Material from Dumpexams with 78 Questions: https://www.dumpexams.com/HPE2-W09-real-answers.html